There are many factors that affect the production capacity of the sand making machine, including the factors of the equipment itself and factors outside the equipment. The equipment itself may be caused by improper operation or manufacturing problems of the manufacturer, which basically needs the assistance of the manufacturer. We can avoid problems outside the equipment. The following summarizes several factors outside the equipment that affect the production capacity of sand, including the hardness, humidity, viscosity, proportion of fines, and material composition of the material.

1.Hardness
The impact of the hardness of the material on the efficiency of the sand making machine is obvious. The sand making efficiency of soft rocks (such as limestone and dolomite) is significantly higher than that of hard rocks (such as basalt and diabase), which is reflected in the good crushing effect and high sand formation rate . Although there is sufficient self-attack crushing in the sand making machine, it cannot completely offset the reduction in crushing efficiency.

2.Humidity
Humidity will also affect the efficiency of sand making, especially for materials with large mud content or limestone. Humidity will increase viscosity and easily attach to equipment, causing a certain degree of efficiency reduction. But this is actually a double-edged sword. After the wet material is crushed, it is easier to form a material layer on the guard plate.

3.Viscosity
As mentioned above, if there is clay in the material, it will affect the efficiency of the sand making machine.

4.Fine material ratio
The proportion of fine material is large, and it is easy to form a large amount of powder, which is not conducive to the production of sand in the building. It is recommended that it be screened out *. If it is a soil component, it needs to be processed in advance.