Why does the cone crusher block material? Generally speaking, the cone crusher will not block the material, because of the crushing principle of the equipment, but in case of material blocking, we can start the implementation of the solution according to the following factors that cause the material blocking:

    1. The discharge port of the cone crusher does not change according to the change of the feeding nature, so that the crushed material cannot be discharged in time, and stays in the crushing chamber, which causes the equipment to block the material.

    2. The equipment damage caused by the stagnation of the cone crusher due to the failure of the motor will cause the materials in operation to be blocked in the equipment. The equipment should be sped in time to discharge the materials and then the equipment should be repaired.

    3. Due to the serious wear or damage of the cone crusher's dynamic and fixed cones during work, some oversized materials will be blocked at the discharge port, which will cause equipment clogging. Cone and fixed cone, deal with problems in a timely manner.

    4. Crusher blocking due to improper feeding should pay attention to keep the feeding uniform, not too much or too little. Iron or other large pieces of non-crushed material that enter the crushing chamber cannot be discharged and cause the cone crusher to block the material, or the feeding properties are not suitable. The cone crusher is not acceptable.